Co-ax Pressure Control Valves

The valve controls tanks and reservoirs emptying and avoids overflow. The valve operates by means of a differential hydraulic float complete with regulating levels mounted on the tank side. The float maintains the valve closed and opens only when the minimum pre-set level is reached. Once the valve is open, float allows tank inlet until maximum water level is reached again.

Brake force control valve for stepless regulation of the brake pressure.

The pressure relief valves GEMÜ N085 and N185 protect the plant and the piping system against gauge pressure and reduces pressure peaks. The third pipe spigot enables the valve to be installed in the main pipe. If the pressure increases, the spring is raised and the valve opens. The pressure is reduced to the preset value and can escape via the third pipe spigot into an adjacent pipe. If the pressure falls, the spring force presses the diaphragm in the direction of the seal seat and it is closed. The spring force can be adjusted as required using a set screw. - Valve adjustments can also be made under working pressure. - The optimization of piston, springs and control face ensures good control characteristics - The actuator is hermetically separated from the medium

We manufacture rough or fully machined cage and seat for pressure control valves & control valves in : • Austenitic stainless steel Alloys (CF8M, CF3M…) • Aluminium-Bronze (UNS C95500…) • Duplex and Super Duplex (CD4MCu, CD3MN…) • Nickel-based and high-alloys (CW-6MC, CU5MCuC, M-35-1 CW-12MW…) • Martensitic alloys (CA15, CA6NM…) • Other materials on request